Guide
Threading a tapestry needle
Thread wool, stranded floss, and other needlepoint fibers while checking needle-eye fit and avoiding damage from an overloaded threader.
Threading should not require repeatedly crushing or pulling the thread through an eye that is too small. Start with a clean thread end and a tapestry needle whose eye accommodates the working bundle. John James describes its tapestry needle as having a large eye and blunt tip; those features serve different jobs, so check both the threading fit and the canvas fit.
If you are using divisible floss, prepare the chosen strands before threading. A loose bundle that changes from four strands to three halfway through the eye will not behave consistently in the stitch.
The pinch-and-pass method
Cut away a badly frayed end. Hold the thread close to its tip between thumb and finger so that only a short, controlled end is visible. Bring the needle eye toward that end, rather than trying to push a long floppy length across open space.
For a soft thread, fold it over the needle shaft to make a small crease, pinch the fold, then remove the needle and present that compressed fold to the eye. Draw the folded part through and pull one end to create a normal single working length. Do not stitch with the doubled bundle unless that is the preparation you intended.
Keep the loose tail through the eye long enough that it does not slip out immediately. As you stitch, shorten that loose tail when necessary rather than letting a worn section repeatedly travel through the canvas.
If you use a threader
Use a threader designed for the needle and fiber. Some tools intended for fine sewing needles are not suitable for a bulky needlepoint thread. Insert the threader, load only the intended bundle, and draw it back gently.
Clover’s threader instructions specifically caution against forcing the wire and note that thread thickness and eye size affect compatibility. If resistance is high, stop. A different needle or a more suitable threader is preferable to breaking the tool inside the eye.
Diagnose the point of resistance
A bundle that will not enter the eye suggests a threading-fit problem. Thread that enters easily but abrades while passing through the canvas suggests you should also inspect the needle size, canvas holes, and working length. These are different problems.
Use choosing a tapestry needle to check the complete needle–thread–canvas combination. If you are unsure whether to split the thread, read stranded versus non-divisible thread first. Keep product labels nearby so that a successful preparation can be repeated without guessing how many strands went into the needle.
Keep learning

Learning path
Your first needlepoint canvas: a learning path
Follow a linked beginner path from choosing a canvas and planning its finish to starting threads, stitching, and checking your first project.

Guide
Choosing a first needlepoint project
Choose a first needlepoint project by comparing design complexity, mesh, included supplies, finishing needs, and a practical buying checklist.
